高氯化聚乙烯底漆.doc

高氯化聚乙烯底漆Intended Uses用途專用于混凝土或鋼結構設施表面涂裝底漆，有優良的耐堿性能，對混凝土底材有很強的滲透性和封閉性，漆膜附著力強、干燥快、施工方便。Especially used for protecting surface of concrete or steel installations as primer. It forms a coating with excellent resistance to alkali, high penetrability and sealing. High adhesion, quick dry and easy application. ProductDescription產品簡介有鐵紅，淺灰等色。Iron red, light grey, etc.ProductInformation產品數據Volume Solids 體積固體份35%Dry Film Thickness 干膜厚度35-40 microns equivalent to 100-115 microns of wet film35-40微米相當于100-115微米濕膜厚Theoretical Coverage 理論涂布率8-10m2/Kg 8-10平方米/公斤Practical Coverage 實際涂布率Allow appropriate loss 允許適量損耗Application Details施工詳述Mix Radio 混合比One pack 單罐裝Method of Application 施工方法 Airless Spray 無空氣噴涂 Recommended 推薦采用 Brush or Roller 涂刷或輥涂 Recommended 推薦采用 Conventional Spray 傳統噴涂 Recommended 推薦使用 Thinner 稀釋劑 C001Cleaner 油漆設備清洗劑 C001Pot Life 使用期 Not limit 不限制Storage 貯存期 One year 一年Drying time 干燥時間SubstrateTemperature底材溫度,Touch Dry表干（h）Hard Dry硬干(H）Over coating Interval覆涂間隔Mix最短Max最長1025 35 12424 h8 h6 h 7 dStorage andHandling貯存與管理Storage 貯存 Store in cool and dry conditions 貯存于陰涼干燥處 Pack size 包裝規格 25Kg in 20 liter container 25公斤裝于20公升容器中Flash Point 閃點 38 Specific Gravity 比重 Approx 1.25Kg/L 1.25公斤/公升Specification and Surface preparation技術要求及表面處理Steel surface: clean to Swedish Sa2.5 or rust-removed manually or with power tool to Swedish Standard St3. Concrete surface: Remove oil, grease and dust etc, prior to application鋼材表面：噴射除銹至瑞典標準2.5級或手工除銹或動力工具除銹達瑞典St3級混凝土表面：除去表面油脂，灰塵等Limitations限制Subsequent coat: Highly chlorinated polyethylene anti-corrosive finish with all colors后道配套涂料：各色高氯化聚乙烯面漆Safety Precautions 安全措施The product must be used in painting area by professionals. When painting, please be sure to refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying the product.The product is a kind of solvent-based paint. In order to avoid the accident or dangerous occurrence, minimal safety precaution, as follow, should be down.The paint contains volatile solvent and it is flammable, So must keep away from sparks and open flames. No smoking at workplace, Effective precautions (such as using explosion-proof electrical equipments. No static electricity accumulation or metal collision etc) also should be done so as to avoid product sparks. Enough ventilation is necessary at application sites. In order to remove any danger of explosion, must keep the ratio of gas / air is less than 10 %, Usually 200 m3of ventilation quantity per 1 Kg solvent (according to the solvent) is necessary, it canMaintain the minimum explosive limit. Take effective precautions to prevent skin and eye contact with the coating (such as the use of overalls, gloves, goggles, face shields and protective oil coating and so on). If paint gets in touch with skin,If accidental skin contact with the product, please use fresh water and soap or an appropriate industrial cleaning agents thoroughly cleansed. In case of eyes being contaminated, rinse with fresh water for 10 min at least and give medical treatment immediately.During painting, it is recommended to wear face shields to prevent inhalation of paint mist and harmful gases.Especially in poorly ventilated environment, it is more necessary.Finally, be handled with care so as not to waste paint barrels of pollution of the environment.NOTICE: If consumers have not taken effective safety precautions (Refer to the specification), our company will NOT be responsible for any accident. 本產品必須由專業人員在工業場所使用。使用時請務必參照本說明書以及相關健康安全手冊。若客戶在使用本產品前,未能詳細了解本產品的相關健康安全知識,請與本公司人員聯系。該涂料為溶劑型涂料，為避免事故或危險發生，應采取最低限度的安全措施如下：此涂料為易燃物,并含有揮發性易燃溶劑，故必須遠離火星和明火。嚴禁在作業場所吸煙，并應該采取有效措施，防止火星產生(如采用防爆電器設備，杜絕靜電積累,避免金屬撞擊等)。 施工場所應盡量保持良好通風。為消除使用過程中的爆炸隱患,應保證足夠的通風量以維持氣體/空氣比例不超過最低爆炸極限的10 %,通常每千克溶劑需要200立方米通風量,(與溶劑種類相關)就能維持最低爆炸極限10 %的工作環境。 采取有效措施，防止皮膚和眼睛與涂料直接接觸(如使用工作服,手套,護目鏡,面