ALOM密碼清除

1、 ALOM密碼清除（v 1.0）作者陳 亮審核分類Solaris子類硬件更新時間2010/10/11關(guān)鍵字ALOM摘要清除ALOM密碼主要適用環(huán)境ALOM4v版本說明版本號擬制/修改責(zé)任人擬制/修改日期修改內(nèi)容/理由V1.0陳亮2010/10/11初稿目錄版本說明21 ALOM4v 密碼清除32 清除步驟41 ALOM4v 密碼清除If the password for ALOM4v is lost or forgotten then the following password recovery steps can be taken to erase/reset the ALOM NVRAM

2、 so that a user can gain access to ALOM, set a new password and restore the NVRAM settings.2 清除步驟Steps to Follow O91XZKG Internal ID use only.Note: physical access to the system so that the power cables can be accessed and a serial connection can be made to the system is required for this procedure.

3、1. Make a connection to the ALOM serial management port.2. Power cycle the system by unplugging the server's power supplies, waiting several seconds and then plugging the power supplies back in.3. You should see the ALOM booting on the serial management console. Hit "Esc" (the Escape k

4、ey) during the ALOM boot, before or at the point: "Return to Boot Monitor for Handshake"This will cause the system to produce the message: "Return to Boot Monitor for Handshake ESC keypress detected."4. ALOM will now enter the "ALOM boot escape menu" and the following w

5、ill be displayed:ALOM <ESC> Menue - Erase ALOM NVRAM.m - Run POST Menu.R - Reset ALOM.r - Return to bootmon.Your selection: 5. To clear out the existing password you must choose 'e' to erase the ALOM NVRAM. After using the 'e' option to erase the NVRAM choose the 'r' op

6、tion to resume the ALOM boot. You will automatically be logged in as user 'admin' with no password and no permissions. The NVRAM settings will be reset to their factory defaults. Note that since this procedure resets the NVRAM settings to their defaults any customization (such as the ALOM ne

7、twork settings) will need to be recreated. The above procedure can be adapted for the two Blade products Sun Blade T6300Server Module and Netra CP3060 Board which also use the ALOM4v.1. Ensure a working serial connection is made to the serial port at the front of the Blade.2. Power cycle the board by powering off the server as per the relevantarchitecture, unplug the Blade from the